AutoMeter

Professional fit and finish, this mounting solution attaches to the factory pillar effortlessly by utilizing the included mounting hardware

Clean OEM-like fit & finish - Gauges do not obstruct the driver's view of the road and are positioned at optimum viewing angles for at-a-glance readings

Clean OEM-like fit & finish - Gauges do not obstruct the driver's view of the road and are positioned at optimum viewing angles for at-a-glance readings

Clean OEM-like fit & finish - Gauges do not obstruct the driver's view of the road and are positioned at optimum viewing angles for at-a-glance readings

Clean OEM-like fit & finish - Gauges do not obstruct the driver's view of the road and are positioned at optimum viewing angles for at-a-glance readings

AutoMeter steering column gauge mounts (pod) are covers that install over the top of your vehicle's factory steering column shroud, providing a clean and convenient location to install an additional...

This compact 23mm (15/16" ) inductive clamp multimeters are designed to easily enclose small wires and yet are large enough to measure most large wires. You can easily measure computer memory draw,...

Autometer Accessories 0-100PSI 1/8in. NPT Male Oil Pressure Sensor (For Short Sweep Elec.)

Replacement sensor for Spek-Pro 60/100 PSI Boost gauges. 1/8" NPT male thread.

Limits voltage spikes above +16 VDC and all negative voltage below (-) ground caused by inductive loads such as battery changeover switch, starter solenoids, fan motors, etc.

Autometer Accessories Sensor Pressure Spek-Pro 0-150 psi 3/8in-24 Ashcroft

Includes 1/8" NPT sending unit and 3ft. of wiring (red, black, and white)

Replacement sensor for Spek-Pro 100/120/150 PSI pressure gauges, excluding Boost. 1/8" NPT male thread.

Replacement 1/8" NPT temperature sensor for Spek-Pro temperature gauges (oil, water, differential, and transmission).

Includes double male fitting for mating to included weld in fitting or other 1/8" NPT fitting

Stack Instruments Series, Adapter, 1/8" NPTF (F) To M12 (M)

FITTING, ADAPTER, 1/2-1/16" NPT MALE, EXTENSION, BRASS, FOR MECH. TEMP. GAUGE

1/8" NPT Female to Male compression fitting thread designed for AutoMeter 1/8" Nylon or Copper Tubing. Use to connect AutoMeter 1/8" Nylon or Copper tubing to AutoMeter Mechanical gauges.

Autometers New Fully Automatic Fast And Full Charger. This Charger Has Fully Controlled Current Limiting From 1 To 80 Amperes. The 4 Channels Are Put Into A Constant Current/Increasing Voltage Mode...

AutoMeter’s new state of the art AirDrive module provides a plug and play solution that wirelessly transmits data through a secure WiFi network from your vehicle to our award winning AirDrive gauges...