Carroll Shelby Racing Windshield Banner

Top Quality 3M die cut vinyl DECAL

Curved for easy installation

Measurements: 41.25 X 5.62 Inches

Select whether you want to have your banner reflective

Select whether you want to have your CSM/CSX number added

Tell us the colors you want in the box that says "Custom Banner Color"

(Also, tell us what part of the banner you want reflective)

Note: We do our best to color match per the vehicles color code, but decals may not be an exact match.

Example 1:

Carroll Shelby and racetrack: White

Racing: Red

Example 2:

Carroll Shelby and racetrack: White

Racing: Reflective Red

(Once ordered we will contact you to confirm your color)

INSTALL INSTRUCTIONS

*Make sure window is clean and dry - Do not use water to put decal on*

NOTES

It is easiest to apply banners to a warm windshield.

Beware of heavy wind when installing.

Clean windshield thoroughly with water or alcohol, DO NOT use RainX or other polishes. 

1) After thorughly cleaning windshield surface, find and mark the center of the windshield with painters tape. Do not use the rear view mirror as a center point as it may not be centered.

2) Locate and mark the center of the windshield banner. The center can easily be found by folding it lengthwise in two to make a crease.

3) Once centers are found place on windshield so as to become familar with desired location.

4) Recommended method of installation is the Center Hinge. This is achieved by carefully removing a 2"-3" portion of the backing paper from the center.

5) Once this portion of the center is removed, simply fold back each side of the backing paper approximately 1" onto itself

6) Then turn decal over and carefully set it in the desired location, making sure it is centered. When placed correctly, stick the center exposed area down with your thumb.

7) Once "hinged", apply each side of the decal from the center with a squeegee or credit card.

8) Once satisfied, start to peel back the transfer paper very slowly at a sharp angle. If the vinyl appears to be lifting, gently push the transfer paper back down and squeegee that area.

*If after removing the transfer paper you notice bubbles, puncture the vinyl with needle or pin and use squeegee to work out bubbles.

Check out our install video: https://www.youtube.com/watch?v=EdrSyUPJjiU