This cam bolt kit provides caster adjustment by replacing one of the two factory bolts that mount the rearward pivot of the front lower control arm bushing bracket. Elongation of the pre-marked factor holes is required - we recommend using rotary file set 85130 or similar. Includes one smaller cam.
If you are running modern radial tires you should not follow factory alignment specifications for caster, SPC recommends 3deg of caster to promote return to center steering. Stock strut rods on the...
The innovative cam nut and sturdy bracket saves time and money. Easily adjust camber and caster on newer F150s and Expeditions. Save time since you don't have to remove the OE bolt or stabilizer bar...
FOR DOMESTIC/IMPORT-TWO BOLT STRUTS. EZ Cams make non-adjustable two-bolt struts adjustable up to +/- 1.75deg camber change. Head markings show where the cam is for maximum change and an...
FOR DOMESTIC/IMPORT-TWO BOLT STRUTS. EZ Cams make non-adjustable two-bolt struts adjustable up to +/- 1.75deg camber change. Head markings show where the cam is for maximum change and an...
Modernize your early Ford and Mercury front suspension by installing these adjustable upper control arms and adjustable strut rods from SPC. SPC has built +3° of caster into the upper arm to improve...
Modernize your '64.5 to '66 Ford front suspension by installing a pair of adjustable upper control arms and adjustable strut rods from SPC. SPC has built 3deg of caster into the upper arms to improve...
Lifted trucks lose caster which wears tires and leads to wandering at high speeds. These arms improve droop travel, drivability and tire wear as well as adjusting tire position in your wheel well...
This heavy duty cam-bolt kit was specifically designed for the extreme Raptor & F-150 user. Whether you are a energetic Raptor driver or abuse your F-150 in the fields and on the job site, you...
This cam bolt kit changes camber up to 2-1/2deg. It includes an adjusting plate to make the camber adjustment possible. After elongating the lower strut/spindle bolt hole with a rotary file, install...